Pneumatic micro filing machine MAH-16, 11.000 min-1 - Nitto Kohki 111100001

Engravings, small radii and fine edges are hard to reach with a standard filing machine because the tool simply does not fit the geometry. These micro filing machines weigh 0.37 kg, work with strokes of 0.5 to 2.2 mm and need only 0.07 m³/min of air.

• Short strokes of 0.5 to 2.2 mm keep the tool controllable inside small contours and engravings.
• Stroke rates of 11,000 to 22,000 per minute give even material removal at low contact pressure.
• A tool weight of 0.37 kg allows pen-like guidance.
• Air consumption of 0.07 m³/min is low, so several stations can run off one supply.
• One flat and one round diamond file are included, along with a hex key and a quick coupling for connection.

Technical data

Applications

• Reworking engravings and embossing tools
• Deburring small bores and cut-outs
• Fine rework on injection moulds
• Preparing small parts for polishing
• Work on metal and plastic prototypes

Standard accessories

• Each 1 pc. of diamond flat and round file
• Hex. Wrench key 2 : 1 pc.
• Cupla Model HA-658N : 1 pc.

Operating principle

An air motor converts the air supply into a short linear oscillation of the clamped file. The short-stroke version runs at the higher stroke rate, so the two versions differ in the level of fineness they reach.