Proxxon 28940 MICROMOT Collets, 6 pcs. with collet nut and holder, 1 - 3.2 mm

MICROMOT steel collets
As described below. Fit all handheld MICROMOT machines, excluding the engraver GG 12. One each 1.0 - 1.5 - 2.0 - 2.4 - 3.0 and 3.2mm, clamping nut and holder for storage are included.

NO 28 940



Note:
MICROMOT steel collets are hardened and thus have a high, consistent flexibility. They also maintain prolonged accuracy, even after regular use (these collets should not be compared with unhardened, fourslit collets of brass and aluminium). The triple slit collet is substantially more difficult to manufacture than the four-slit type, but offers a better load-bearing surface. This is especially important for cutters with small shaft diameters.

• Proxxon 28940