4-Tool ESD Rework Station, 160 W/Tool, with MSE Desoldering Module - JBC DMPSE-2QB

The JBC DMPSE-2QB is a complete 4-tool rework station from the Premium Line for board-level repair and desoldering. The DMU control unit manages up to four tools simultaneously and is compatible with ten different JBC tools, bringing soldering, desoldering and SMD handling together on a single bench.

Benefits

• Four tools in parallel from one control unit: T210-A precision handle, T245-A general-purpose handle, AM120-A adjustable micro tweezers and DR560-A desoldering iron.
• Electric MSE desoldering module with built-in vacuum pump for clean through-hole rework without external compressed air.
• Most Efficient Soldering System: fast heat recovery for stable tip temperature and short work cycles.
• Sleep and Hibernation modes lower tip temperature during idle periods and extend tip life.
• Excellence features: station customization, full process control and remote management over LAN.

Technical data

• Peak power: 160 W per tool at 23.5 V
• Selectable temperature range: 90 to 450 °C / 190 to 840 °F
• Vacuum (at 6 bar): 75 % / 570 mmHg / 22.4 inHg
• Flow rate (at 6 bar): 9 SLPM
• Interfaces: USB-B (PC software, traceability), USB-A (firmware, soldering graph, Dino-Lite AM2011/AM2111), RS-232 robot/fume extractor, LAN remote control
• Equipotential bonding: optional EPA connection, tip-to-ground resistance < 2 ohms, tip-to-ground voltage < 2 mV RMS
• Operating environment: 10 to 50 °C / 50 to 120 °F
• Control unit dimensions: 232 x 148 x 120 mm
• Weight: 12.79 kg (station), 17.91 kg packaged

Applications

• Rework and repair on through-hole and SMD assemblies
• Through-hole desoldering with the DR560-A desoldering iron
• Fine work with the precision handle and micro tweezers
• Service and repair benches in electronics manufacturing, labs and maintenance

In the box and compatibility

Supplied with the DME 4-tool control unit, MSE desoldering module, T210-A, T245-A, AM120-A and DR560-A plus stands, cartridge holder and pedal. Tips and cartridges are not included: the T245 uses C245 tips, the T210 the C210 range, the AM120 takes C120 cartridges and the DR560-A uses C560 desoldering nozzles.

Standards

ESD safe per IEC 61340-5-1. CE, RoHS. Made in Spain.