Pneumatic beveler AMBL-0307 - Nitto Kohki 135600001

Where compressed air is already available at the workstation, the pneumatic beveler removes the need for a power cable. It weighs just under three kilograms, chamfers edges from 0C to 7C and works at a chamfer angle of 15 to 45 degrees.

• Driven by the existing compressed air supply, no mains cable and no extension lead at the part
• Chamfer capacity up to 7C plus radii from 2R to 4R, covering edge breaking and weld preparation with one tool
• Chamfer angle infinitely adjustable from 15 to 45 degrees, so the weld preparation can follow the drawing
• Weight below three kilograms, which keeps the tool manageable along longer edges
• No load air consumption is stated at 0.9 m3/min, so compressor and line sizing can be planned in advance

Technical data

Applications

• Deburring and chamfering sheet metal edges during assembly
• Weld preparation on steel components
• Edge breaking on milled and sawn parts
• Rework of flame cut and laser cut edges
• Workstations with a permanent compressed air supply

Standard accessories

• Hex.Socket Screw key 3 & 4 mm: each 1 pc.
• Spanner: 1 pc.

Operating principle

An air motor drives the cutter head. The base plate rests on the workpiece and limits the infeed, with chamfer size and angle set before the cut.