Bernstein 9-270-ESD. ESD PCB holder SPANNFIX Vario for clamping + cable

Area of application

The SPANNFIX VARIO can be used to clamp PCBs / circuit boards up to a length of 270 mm. Due to the infinitely adjustable ball, the PCB can be positioned and held securely in all directions. A quick turning of the PCB`s / boards is possible thanks to the adapter.
Very helpful as a third hand when soldering or assembling, useful clamping and holding device with quick clamping mechanism.

Technical description

Connection thread M12 x 1.5 mm (special thread). Please contact us for suitable adapters.
Maximum torque: ball Ø 40 mm approx. 24 Nm, ball Ø 60 mm approx. 100 Nm
holding force of the ball at the height of the threaded pin: ball Ø 40 mm approx. 45 kg (441N), ball Ø 60 mm approx. 140 kg (1.372N). The clamping force is increased by degreasing the ball.
Clamping base: table thickness max. 80 mm
Screw-base: 4 x 9 mm through holes
Magnetic base: holding force 32 kg horizontally, 15 kg vertically (magnet without cap)
ESD versions dissipative 10^7 and 10^8 ohm
EPA suitable for electrostatically protected areas (ESD workplace / ESD protection zone). The foot sections can be connected to the grounding point with a 10 mm push button.
Cast aluminum parts powder coated
Steel parts chrome-plated, rust-free
For safety-relevant parts, please note that we cannot give a guarantee of the holding forces without knowing your specific application. The ball may behave differently under different physical conditions than it does in our test laboratory in an optimal test environment.

Content

Ball joint combination consists of:

• 9-251 ESD ball joint base SPANNFIX for re-connecting (threaded ends 20mm)
• 9-253 ESD circuit board holder for screw on (M12+1.5)
• 9-256 ESD clamping lid for PCB holder
• 9-257 ESD rapid turning device for PVB holder
• 9-343-1 ESD grounding cable 1 MOhm, 1800mm 2 press-studs 10/10mm