Bosch Rexroth 3842558005. Connection kit active belt bridge 120 R

The active belt bridge is used as transfer unit for bridging the conveyor trench between the basic unit and the Return unit between section start or end and a third-party conveyor or in connection drive

• Only for flat conveyor chain and static friction chain
• The active belt bridge is driven by a transmission (on the drive or Return unit side)
• Suitable for conveyed materials from approx. 80 mm in length (depending on the speed, position of the center of gravity, product friction, etc.)
• Installation possible on both the drive and Return side (make sure to use the correct L/R version)
• Not permitted for wet operation, rough ambient conditions or sharp-edged products
• Accumulation not permitted
• Load depending on the speed (see diagram)
• The speed of the adjacent conveyor should be approximately the same to prevent premature wear
• Simple transmission of the drive force using hexagonal hollow shafts integrated into the base unit or Return unit as standard
• Can be retrofitted into a standard configuration at any time
• Easy replacement of the belt from the top