Wideband signal clamp 80 mm with 3 m lead, 256 Hz to 200 kHz - Leica ULTRA

Choosing the right frequency decides whether a trace works. Low frequencies travel far but couple easily onto neighbouring lines, high frequencies couple even onto poorly conducting targets but do not reach as far. According to the manufacturer text the Leica wideband signal clamp covers 256 Hz to 200 kHz, so both strategies are available from a single clamp.

Benefits

• Frequency range 256 Hz to 200 kHz, low frequencies for reach and high frequencies for difficult targets from one accessory.
• 80 mm internal diameter, sized for the usual cable and pipe diameters in the distribution network.
• 3 m lead, the signal transmitter can stay outside the chamber while the clamp is applied below.
• Coupling without switching off, the signal is applied around the line and service continues.
• Original accessory with EAN 7640180530367, listed by the manufacturer for use with the ULTRA signal transmitters.

Technical data

Applications

Locating live power cables, identifying single lines in a chamber, coupling onto poorly earthed lines using high frequencies, tracing over longer distances using low frequencies.

Compatibility and scope of delivery

The manufacturer text lists the clamp for use with the Leica ULTRA signal transmitters, connected to their output through the 3 m lead. The clamp is supplied with the lead attached, transmitter and receiver are not included.

Standards and origin

Original accessory from Leica Geosystems, material number 832972, EAN 7640180530367, customs code 8536309090, country of origin United Kingdom. The price book short name states a frequency range of 512 Hz to 33 kHz while the detailed manufacturer text states 256 Hz to 200 kHz. Both figures are shown separately on purpose, and the value should be confirmed with the manufacturer before any frequency critical use.