Solder Wire Feeders and Dispensers
Reeco Soldering Technology
Repetitive steps cost time and accuracy as soon as they are metered by hand. The TD-1 solder wire feeder delivers the set amount of solder, triggered from the switch on the handpiece or a foot switch, so the second hand stays on the component. The RE-1900 pneumatic dispenser does the same for adhesive and solder paste: dispensing time and pressure are set, and every dot comes out alike.
Both units belong on an ESD bench. The TD-1 has a grounding connector and is set up as standard for 1 mm wire, with 0.8 or 1.5 mm available depending on version. The RE-1900 dispenses from 0.01 ml with a repeatability of ±5 percent and is fed from 10 and 30 cm3 syringes with matching plastic and stainless steel needles.
| Article | Type | Key figure | Operation | Accessories |
|---|---|---|---|---|
| RE-TD1 | Solder wire feeder | 1 mm wire as standard, 0.8 and 1.5 mm by version | switch on the handpiece, optional foot switch | holder to iron type, power supply |
| RE-1900 | Pneumatic dispenser | 0.01 ml, repeatability ±5 percent | foot pedal or button on the syringe adapter | syringes 10 and 30 cm3, needles, adapters |
Typical applications: Repetitive soldering in production and repair, work under a magnifier lamp or microscope, spot bonding and potting, applying solder paste and flux in small series, laboratory and prototype work.
