Glue-down tiles
Glue-down tiles sit between sheet flooring and loose laid interlocking tiles: they are fully bonded and earthed like sheet material but follow a tile grid. That pays off wherever there is a raised access floor, where sections are to be replaced later, or where colour fields for zoning need clean boundaries. Listed here are the ESD glue-down tiles from the Gerflor programme.
Categories
All areas for Glue-down tiles
Pick an area to see its products and filters.
In detail
System comparison
The key data in table form.
| Range | ESD rating | Format | Distinctive feature |
|---|---|---|---|
| Mipolam Technic EL5 | conductive, 104 to 106 Ω | tile 608 x 608 x 2 mm | very low particle release, microelectronics |
| Mipolam Robust EL7 | dissipative, 106 to 108 Ω | tile 608 x 608 x 2 mm and roll 200 cm x 20 m | 3300 g/m², for raised access floors |
| Mipolam EL7 (on request) | dissipative, 106 to 108 Ω | tile 608 x 608 mm from 500 m² | all ten EL7 colours as tiles |
All three ranges are fully bonded with conductive adhesive and connected to the equipotential bonding through a copper strip grid.
Applications
Typical applications
Where these products are typically used.
- raised access floors in data centres
- control rooms and plant rooms
- microelectronics and semiconductor manufacturing
- measurement rooms with particle requirements
- and areas whose layout changes and where individual fields are swapped instead of relaid
- Adhesive-free alternatives are listed under interlocking floor tiles
- continuous surfaces without a joint grid under sheet flooring. Matching conductive adhesives and earthing and adhesive tapes are listed separately
FAQ