Clamp Set of 2 for Round Tube 38 to 50 mm for Mounting the MC200 Depthmaster - Leica 726175

The MC200 Depthmaster only measures reliably when it sits tight and plumb on the stick. On round or square boom tubes no magnet will hold, and that is where this clamp set comes in. The two clamps grip the sensor onto round tube of 38 to 50 mm diameter or square tube of 38 mm. This item is the accessory, not the sensor.

Benefits

• Firm clamped joint: the sensor stays in place through vibration and knocks against the trench wall, which a magnetic bracket cannot manage on round tube.
• Two tube shapes covered: round tube 38 to 50 mm and square tube 38 mm, so the set fits the usual booms of excavators and backhoe loaders.
• Set of two clamps: the sensor is held at two points and cannot twist under load.
• Original Leica Geosystems part: material number 726175, the seat matches the MC200 Depthmaster housing without any rework.
• Easy to reorder: EAN 7640110690239 and customs code 9015900000 are on file.

Technical data

Applications

Mounting the MC200 Depthmaster on excavators and backhoe loaders, permanent installation on one machine, booms with round or square tube sections, machines without a flat ferrous face for the magnetic bracket.

Compatibility and scope of delivery

The clamp set belongs to the accessory range of the Leica MC200 Depthmaster. Delivery covers the two clamps only, without the sensor. Anyone moving the Depthmaster between machines often should take the magnetic bracket, material number 726176, which holds on any flat ferrous surface instead.

Origin and identification

Original Leica Geosystems accessory, material number 726175. Country of origin Switzerland, customs code 9015900000, EAN 7640110690239.