Dual output cable for remote switching between two utility lines - Leica ULTRA

Separating two lines that run in parallel usually means injecting on one after the other and walking back to the transmitter each time. The dual output cable for the Leica ULTRA Advanced signal transmitter puts the signal on both lines and, according to the manufacturer, allows remote controlled switching between them, straight from the route.

Benefits

• Remote switching between two lines, the change happens without walking back to the injection point.
• Two outputs on one transmitter, both lines stay connected, so nothing has to be re-clamped in the chamber.
• Clear separation of parallel routes, because the signal can be assigned deliberately to one line or the other.
• Less walking time for the crew, particularly on long routes and at awkward injection points.
• Original accessory with EAN 7640180530343, specified for the ULTRA Advanced signal transmitter.

Technical data

Applications

Separating cables and pipes laid in parallel in the same trench, assigning two outgoing circuits from one distribution board, route surveys with alternating injection without a second transmitter, locating in densely occupied chambers.

Compatibility and scope of delivery

The manufacturer specifies the cable for the Leica ULTRA Advanced signal transmitter, because that unit supports remote control of the switching. Where only one output is needed, Leica lists the single connection cable under material number 818713. The cable is supplied on its own, transmitter and receiver are not included.

Origin

Original accessory from Leica Geosystems, material number 818711, EAN 7640180530343, customs code 8544429090, country of origin United States.