Target assembly 300 mm red with small insert for Piper pipe lasers - Leica 725858

A pipe laser is only as accurate as the target it is aimed at. This target assembly for 300 mm pipe is placed at the leading end of the run and makes any deviation of the laser spot from the design line visible. The small insert narrows the target aperture and allows finer centring than the wide base opening on its own.

Benefits

• Matched to 300 mm pipe diameter, the target sits form-fitted in the pipe and needs no aligning or wedging.
• Small insert for fine centring, the line can be held tighter than with the open target face alone.
• Red version for high-contrast reading of the target spot under site lighting.
• Plastic build at 0.513 kg, light enough to handle in the trench and easy to rinse off.
• Compatible with the whole Piper line, Piper 100, Piper 200, Piper 100G and Piper 200G.

Technical data

Applications

Sewer and waste water pipe laying in 300 mm nominal bore, storm water sewers, collector lines and the renewal of existing runs, wherever line and fall are checked across a full pipe section.

Compatibility and scope of delivery

Supplied is the target assembly with its small insert. Leica Geosystems offers further targets for other nominal bores, matching feet for 150, 200, 225, 250 and 300 mm as well as the trivet with mounting bracket for set-up inside a manhole. The assembly works with every pipe laser in the Piper line.

Standards and origin

Weight 0.513 kg, EAN 7640110696101, customs code 3920690090, country of origin China. Original accessory from Leica Geosystems.