Electronics side cutter Electronic Super Knips XL, INOX surgical steel, 140 mm - Knipex 78 03 140

When shortening cable ties or trimming the finest wires, the last tenth of a millimetre decides whether the rest of the assembly stays clean. The Electronic Super Knips XL 78 03 140 cuts wires lying flat against a surface from 0.2 mm dia. and is 15 mm longer than the standard version, which raises stability and cutting performance.

Benefits

• An additional 15 mm of length over the standard version brings greater stability and greater cutting performance.
• Ground, very sharp cutting edges without bevel for ultra fine cutting work in electronics and precision mechanics, in particular for cutting cable ties to length.
• Shear cut with controlled micro cutting edge offset for a long service life and a highly precise cut on even the thinnest wires.
• Precisely shaped tips also cut wires close to a surface from 0.2 mm dia., soft wire up to 2.1 mm dia., medium hard wire up to 1.2 mm dia.
• Extremely smooth movement with opening spring and opening limiter for minimum operator fatigue across a full shift.
• Durable and stainless, made of INOX surgical steel, joint with stainless steel rivet, cutting edge hardness about 54 HRC.

Areas of use

PCB assembly and rework, precision mechanics, model making, test benches and repair work on modules. The longer body helps wherever you have to reach deeper into an assembly.

Standards and conformity

The manufacturer does not state a tool standard for this product. No ESD suitability is stated for this version, the 78 03 140 ESD variant covers that requirement. According to the manufacturer the pliers contain no substances of very high concern under REACH, the RoHS directive does not apply.