Spare tilting clasp side for tool case 00 21 37, set of 2, 40 x 65 mm - Knipex 00 21 99 V31

If a side closure springs open during transport the tools end up scattered in the vehicle. This set of two side tilting clasps of 40 x 65 mm each replaces the original parts on tool case 00 21 37 and keeps the lid reliably shut.

Advantages

• Two clasps per set for both sides of the 00 21 37 case
• Original Knipex spare part, fits without drilling or adjusting
• Size of 40 x 65 mm as installed on the series case
• 100 g for the set, far lighter than buying a replacement case
• Keeps the existing case together with its established tool layout

Areas of use

Repair of the 00 21 37 tool case in the electrical trade, in customer service and on site when the side closures are worn after frequent transport.

Standards and conformity

According to the manufacturer the spare part contains no substances of very high concern under the REACH regulation. The RoHS directive is not applicable to this component.