Angle head WH150S, up to 150 Nm, 1/2 in square drive - Bosch Rexroth 3608876064

The WH150S angle head is designed for heavily loaded joints up to 150 Nm. Its low 1.1 reduction ratio means the attached ErgoSpin VarioLine provides most of the torque itself, while the 1/2 in square drive transfers it to the fastener.

Benefits

• 1/2 in square drive: sockets with this drive fit directly, no adapter needed.
• Up to 150 Nm at the output: the maximum torque defines which joints the head is approved for.
• Reduction ratio 1.1 at 0.95 efficiency: torque rises by this factor, speed drops accordingly.

Specifications

Applications

• Heavily loaded joints on frames, axles and load-bearing structures
• Side-mounted joints with high tightening torque
• Workstations where an ErgoSpin VarioLine is to work with an angled output

System compatibility

• Mounts on the ErgoSpin VarioLine (manufacturer data, WH series)
• Manufacturer documentation: WH, ESI, ESO