Desoldering Braid Sea Braid, antistatic, 1.27 mm x 3.05 m, pack of 25 - Desco S-B-10AS

Board rework calls for removing excess solder from pads and leads quickly, without heat building up. Sea Braid is woven from clean, oxide-free copper wire in a tight pattern, so a short length soaks up the solder and you use less braid per joint.

This version is 1.27 mm wide and 3.05 m long, wound on a static dissipative bobbin in line with the ESD Association standard. Each pack holds 25 bobbins.

Key benefits

• Lower consumption: concentrated fine weave of 64 copper strands takes up a lot of solder over a short length
• Short dwell time: tight weave of oxide-free copper allows quick on and off desoldering, which protects pads and components
• Free choice of flux: works with any flux, so your qualified soldering process stays unchanged
• Shelf stable: coated copper braid that is protected against oxidation and picks up solder cleanly
• ESD safe: static dissipative bobbin, each bobbin stamped with a lot code for traceability

Applications

Rework and repair of printed circuit boards, computers, mobile phones and other electronics, desoldering SMD and through-hole components, cleaning pads before re-population. The right choice when your process specifies a particular flux that is applied separately.

Standards

Flux classification per IPC J-STD-004B. Bobbins are static dissipative in line with the ESD Association standard and suitable for use in an EPA.