Conical Sharp Bent 30° Soldering Tip 0.4 mm for TD-200 - PACE 1130-0003

With a straight tip, soldering under overhanging parts quickly turns into contortion. The 1130-0003 from the Standard Blue Series is bent at 30°, so its 0.4 mm point lies flat on the pad while the TD-200 handpiece stays in a natural position.

Benefits

• 30° bend for low-angle access and a relaxed wrist.
• 0.4 mm point for fine-pitch leads and small chips.
• Better view of the joint, as the handpiece is held off to the side.
• Tip-Heater Cartridge with the heater in the tip.

Specifications

Applications

• Leads under heat sinks and connector housings
• Joints in corners and near enclosure walls
• Fine soldering at a low approach angle

Compatibility

• TD-200 AccuDrive Tip-Heater Cartridge Iron
• Stations with TD-200: ADS200, MBT360