Quick connect coupling Purge Line Cupla RE-PV-30, brass - Nitto Kohki 329806609

A line that is vented before it is parted needs a defined point for that step. The Purge Line Cupla is the coupling for such purge and vent lines, and model RE-PV-30 has a brass body and a nitrile rubber (NBR) seal.

• Brass body, an established material for compressed air and gas lines
• Nitrile rubber (NBR) seal, the usual sealing material for compressed air lines
• Connected and parted by hand, so opening and closing the line needs no tool
• Range intended for purge and vent lines, where the parting point is part of the routing
• One clearly designated model RE-PV-30, which keeps selection and reordering simple

Technical data from the manufacturer catalogue

Dimensions

Dimensions in millimetres. Values in brackets apply in the connected condition.

Operating principle

• Residual pressure can be released by a mere lever turn. Very smooth connection/disconnection!
• Single action, just push in the plug to connect regardless of internal pressure in socket.
• No unpleasant noise of air pressure discharge and no hose whip motion on disconnection for safety operation.
• Safe design - socket valve will not open or close unless plug is connected.
• Even after connection, a lever turn will open/close valve with perfect control of air flow or line shut-off.
• Enables simultaneous air supply to three outlets from a single air line. (A single outlet PURGE HI CUPLA is also available - see the pages of PURGE HI CUPLA for details.)

Series comparison

Choose PURGE LINE CUPLA when one air line has to feed three outlets and residual pressure must be released before disconnection: the lever on each PV-30SM outlet socket opens and closes the valve even after connection, which the plain one-way shut-off siblings HI CUPLA BL, NUT CUPLA, LOCK CUPLA 200, HI CUPLA Two Way Type, ROTARY LINE CUPLA, ROTARY FULL BLOW LINE CUPLA, ROTARY PLUG and TWIST PLUG do not offer. For a single outlet with the same purge function, PURGE HI CUPLA is the counterpart. Its working pressure is 1.0 MPa {10 kgf/cm2}, so lines running at 1.5 MPa {15 kgf/cm2} call for one of the 1.5 MPa {15 kgf/cm2} series instead, and where two-way shut-off with reduced spillage is required, COMPACT ZEROSPILL CUPLA applies.

Body and seal materials

Applications

• Purge and vent lines that are parted at a defined point
• Installations whose line is drained before maintenance work
• Line sections released for rebuilding or cleaning
• Maintenance work in which an existing coupling point is replaced

Safety and application notes

• Before use, please be sure to read "Safety Guide" described at the end of this book and "Instruction Sheet" that comes with the products.

All technical data on this page is taken from the Nitto Kohki general catalogue Quick Connect Couplings C01en-b, page 54. The complete catalogue is available for download on this page.