ESD PE foam for storage containers, hard, black, 300 x 300 x 6 mm - Warmbier 4550.06.0300

Parts only rest safely in a storage container if the liner drains charge instead of acting as an insulator. This PE plug-in foam is permanently dissipative through carbon in the material and goes into the container as a ready cut piece of 300 x 300 x 6 mm.

Benefits

• Permanently dissipative through carbon in the material, the effect does not fade over the service life
• Cross linked and closed cell, the surface stays intact even when parts are placed and removed many times
• Abrasion resistant and free from corrosive content, no loose particles or corrosive residues reach the assembly
• Hard grade, the liner does not sag under the weight of heavier components
• Typical surface resistance of 10^7 - 10^8 Ohm on the side without skin and 10^5 - 10^6 Ohm on the side with skin

Application

The cut piece works as a base in ESD storage containers, as an interlayer between stacked boards and as the blank for plug-in inserts that hold single components upright. Inside the EPA the parts stay on a dissipative surface during storage and in-house transport alike.