Cutter for flat ribbon cable up to 56 mm width with try square, 215 mm - Knipex 94 15 215

A ribbon cable cut with side cutters can no longer be fitted cleanly to an IDC connector, because the conductors are crushed and the edge runs at an angle. This cutter severs flat ribbon cable up to 56 mm wide without crushing and at right angles in a single stroke.

Benefits

• Crush-free cut across the full width of 56 mm, the conductors keep their cross-section and can be contacted reliably afterwards.
• A blade length of 56.0 mm cuts the cable in one stroke instead of several attempts.
• The try square on the cutting base guides the cable at a right angle, so the cut runs straight without marking it out.
• The cutting base is exchangeable, which keeps the tool in service once the base is worn.
• An opening spring returns the tool to its starting position after every cut and the locking device secures it when closed.
• Chrome-plated body with plastic grips on the handles, 215 mm long at 346 g.

Areas of use

Assembly of ribbon cables in electronics manufacturing, control system and control cabinet building as well as maintenance of devices and plant. Wherever ribbon cable is cut to length and then fitted with insulation displacement connectors.

Standards and conformity

The manufacturer does not state a tool standard for this model. According to the manufacturer the tool contains no substances of very high concern under REACH. The RoHS directive does not apply.