Pipe wrench 45°, Swedish pattern, 60 mm capacity, 430 mm long - Knipex 83 20 015

Working overhead or in a corner, a straight wrench quickly runs out of swing. The 45 degree angled jaw of this Swedish pattern pipe wrench holds pipes up to Ø 60 mm securely and lets the 430 mm tool turn even where space is tight.

Advantages

• Swedish pattern jaw angled at 45 degrees for overhead work and work in corners
• Teeth offset against the direction of rotation and additionally induction-hardened for a secure bite while tightening
• Gripping surfaces with specially hardened teeth, tooth hardness approx. 56 HRC, for a long service life
• Captive adjusting nut, jaw capacity set steplessly up to 60 mm
• I-beam handle design, high stiffness at 1,408 g of own weight
• Red powder-coated, jaws bright ground

Areas of application

Plumbing and heating installation, pipework and plant construction as well as maintenance. Wherever pipes, sockets and fittings up to 60 mm across flats have to be loosened, held or tightened.

Standards and compliance

The wrench conforms to DIN 5234. According to the manufacturer it contains no substances of very high concern under REACH. The RoHS directive does not apply to this hand tool.