Nut driver with screwdriver handle, insulated to IEC 60900, 12 mm across flats, 237 mm - Knipex 98 03 12

Anyone working on distribution boards and terminal strips under voltage needs a closed wrench head for hexagon nuts rather than a pair of pliers. The 98 03 12 nut driver combines a head with 12.0 mm across flats and an insulated screwdriver handle, 237 mm overall at 150 g.

Benefits

• Closed hexagon head with 12.0 mm across flats, burnished, grips the nut positively and does not round off its corners.
• Head diameter of only 20 mm, so the driver reaches nuts in deep and narrow terminal spaces.
• Ergonomically optimised dual component handle for fatigue reduced work and optimum transmission of force.
• Handle design prevents rolling, the tool stays put on sloping surfaces.
• Handle length of up to 112 mm for high manual torque, 237 mm overall at 150 g.
• Insulation with multi-component sheaths, VDE tested to DIN EN 60900 and IEC 60900 for work up to 1000 V.

Technical data

Areas of use

Electrical installation, control cabinet and control system building, maintenance on distribution boards, busbars and terminal strips. The driver suits every job where nuts of 12.0 mm across flats are tightened or released close to live parts.

Standards and conformity

The tool is built to DIN EN 60900 and IEC 60900 and is VDE tested, which releases it for live working up to 1000 V. According to the manufacturer it contains no substances of very high concern under REACH. The RoHS directive does not apply.