Spare blade for DP50 pipe cutter, usable on both sides, 10 x 6 mm - Knipex 90 23 01 E01

When cutting plastic drain pipes, the condition of the blade decides whether the cut comes out clean. This spare blade belongs to the Knipex DP50 pipe cutter, article number 90 23 01, and can be used on both sides, so one blade carries two cutting edges. At 10 x 6 mm and 4 g it can stay in the tool case permanently as a reserve.

Benefits

• Usable on both sides, turning the blade over puts a second cutting edge to work.
• Knipex spare part for pipe cutter 90 23 01, so it fits the holder without any reworking.
• Dimensions of 10 x 6 mm at 4 g, light enough to carry everywhere as a spare.
• According to the manufacturer it contains no substances of very high concern under REACH.

Areas of use

Plumbing and pipework, maintenance and service on plastic waste water lines. Wherever the DP50 pipe cutter is in daily use and a dull blade holds up the job, the spare blade keeps the next cut going straight away.

Standards and conformity

According to the manufacturer the blade contains no substances of very high concern as defined by the REACH regulation. The RoHS directive does not apply to this product.