Ultimus V dispensing controller 0 to 6.9 bar with RS232 interface - Nordson EFD 7012590

Two component epoxies and UV curing adhesives change their viscosity during a shift. A controller with a fixed time then delivers a different amount in the morning than in the afternoon. The Ultimus V controls dispense time, pressure and vacuum electronically and keeps the deposit stable across the whole job.

Benefits in use

• Pressure range 0 to 100 psi, equal to 0 to 6.9 bar, covering thin as well as viscous media.
• Electronic control of dispense time, pressure and vacuum, so the deposit stays repeatable even with changing viscosity.
• Vacuum control holds thin fluids back in the barrel at rest, which prevents dripping.
• Patterns with up to three different shot sizes can be programmed, a part with dot, bead and fill runs without a changeover.
• RS232 interface for connection to a process computer or machine control, parameters can be documented.
• Benchtop unit, it takes up no more than the footprint of its housing at the dispensing station.

Applications

Processing of two component epoxies, UV curing adhesives, oils, greases and solder pastes, electronics manufacturing, medical devices, laboratory and prototype work, wherever the viscosity of the fluid drifts over time or with room temperature.

Compatibility

The unit works with dispensing barrels connected through a barrel adapter. The deposit cross section is set by the dispensing needle screwed on.

Note on the data

The property table gives neither dimensions nor weight, mains voltage, air connection or the timing range of the dispense cycle.