ESD extraction arm 1200 mm with bench clamp, Ø 50 mm, 1000 mm reach - JBC FAE072

Anyone retrofitting an extraction arm to a bench usually wants to avoid drilling the table top. The FAE072 brings its own clamp and is fixed to the edge of the bench, with an arm length of 1200 mm and a reach of 1000 mm.

Key benefits

• The clamp for bench mounting is included, the workplace stays undamaged and the arm can be moved later.
• Reach of 1000 mm at an arm length of 1200 mm, so the funnel also gets to the rear edge of the work surface.
• Bendable over its whole length, the funnel keeps the position set above the joint.
• Reinforced material lowers the wear caused by constant repositioning and extends service life.
• ESD safe design, suitable for workplaces inside an EPA.
• The FAE control regulates air flow by filter saturation and by the number of connected hoses, so extraction stays even across the filter life.

Applications

Hand soldering, rework and repair positions in electronics manufacturing, laboratory and training, above all on benches that must not be drilled.

Compatibility and scope of delivery

Tube diameter of 50 mm for connection to the extraction units of the FAE range. The mounting clamp is part of the delivery.

Standards and compliance

The arm is declared ESD safe by the manufacturer. Manufactured by JBC Soldering SL in Molins de Rei, Spain.