Special Forming Pliers for 3-Pin Components, All Pins Formed, 5.08 mm Offset - Piergiacomi ESYS01122025

Bending three-pin components with an offset lead pattern by hand takes time and causes variation. These special forming pliers shape all three pins at once and set the 5.08 mm offset, which equals a 0.2 inch pitch.

Benefits

• All three leads formed in one step.
• Defined 5.08 mm offset for the matching PCB pitch.
• Same geometry on every component, less rework at placement.

Note

Special tool for a specific component geometry. Please confirm component type and wire gauge with us before ordering.