AD 401 adjusting device with CCD laser for PCB magazines 701 to 704 - cab 8917401

Setting the width of a PCB magazine by hand costs time and rarely comes out the same twice. The AD 401 adjusting device measures the position of the partition wall with a CCD laser and displays the nominal PCB width directly, which puts repeat accuracy at +/- 0.2 mm and the step size at 0.1 mm. It serves the magazines of series 701 to 704 and 7001 to 7004.

Key benefits

• CCD laser instead of a scale, the partition wall position is measured rather than estimated.
• Repeat accuracy of +/- 0.2 mm at a step size of 0.1 mm, so the result is reproducible between shifts.
• An additional clearance on top of the nominal PCB width can be set separately, which lets assembly tolerances be included.
• Quick travel via the toothed belt and fine adjustment via the tension roller, coarse and fine on one device.
• Wide-range supply from 100 to 240 VAC at typically below 5 W, so the demand on the mains stays small.
• Magazine widths from 320 to 400 mm and PCB widths from 40 to 330 mm cover the running series 700 range.

Operation

• Insert the magazine and fix it against the stop with the clamping lever.
• Release the clamping of the toothed belt.
• Move the partition wall roughly by pulling the toothed belt.
• Fine adjust by turning the tension roller until the nominal PCB width is displayed.
• Secure the partition wall by clamping the toothed belt, then release the lever and remove the magazine.

Applications

Setting up PCB magazines in placement and test, wherever magazines are frequently changed over to new board formats.

Compatibility and scope of delivery

For the cab PCB magazines of series 701 to 704 and 7001 to 7004. Larger magazine widths up to 530 mm and PCB widths up to 460 mm are in preparation according to the manufacturer. Net weight of the device is 10 kg.

Standards and notes

Manufacturer details under GPSR: CAB Produkttechnik, Wilhelm-Schickard-Straße 14, DE-76131 Karlsruhe, www.cabgmbh.com.