ESD precision tweezers type 3C, fine straight tip, 110 mm, rubber grip - JBC HPTR-3CSA

During placement and rework the tip geometry decides whether a component stays put or flicks away. The HPTR-3CSA uses the classic type 3C shape, straight and pointed, over a tool length of 110 mm.

Benefits in use

• Type 3C tip shape, straight, fine and tapering to a point, suited to leaded parts and small SMD packages.
• Tool length 110 mm, the short shaft puts the hand close to the tip and improves guidance accuracy.
• Grip area with ESD rubber coating, listed as ESD safe in the property table.
• Finely worked tip surface for clean contact on delicate components and wires.
• Ergonomic grip section for long placement and inspection shifts without pressure points.
• Sales unit 1 piece, blister pack 146 x 62 x 24 mm for storage in the tool rack.

Applications

Placement and rework in electronics manufacturing, repair and test benches, laboratory and cleanroom, wherever small components are picked and positioned under a magnifier or microscope.

Compatibility and scope of delivery

The HPTR line groups several tip shapes around the same ESD rubber grip, so a bench can be equipped to match the component mix. The tips are fixed to the tool and cannot be exchanged. One tweezer is supplied per sales unit in a 146 x 62 x 24 mm blister pack.

Standards and conformity

The manufacturer's property table lists the tool as ESD safe and the handle as ESD rubber. No resistance value in ohms is stated there, so for documenting an EPA to IEC 61340-5-1 the measured value has to be requested from the manufacturer.