Nano Preheater 300 W for PCBs up to 11 x 7 cm, with Control Console, 230 V - JBC PHNE-2A

Heating small, densely populated boards only from above risks warping and cold joints. The PHNE-2A preheats the assembly from below over a 108 x 70 mm area and reduces the temperature gap during soldering and desoldering. 300 W peak power gives fast ramps on small boards.

Benefits

• Heating area 108 x 70 mm, sized for PCBs up to about 11 x 7 cm.
• 300 W peak power for short heat-up times.
• Two type K thermocouple inputs to control and monitor board temperature.
• Three operating modes: power mode with fixed output, temperature mode regulating to board temperature, profile mode with controlled heating rate.
• Compact unit 179 x 165 x 42 mm, weight 1.2 kg.

Applications

Rework and repair of small assemblies from mobile devices, wearables and sensors, preheating before soldering and removing BGA, QFN and connectors.

In the box

• Heater unit
• Control console
• 2 PH218 type K thermocouples
• PH217 Kapton tape for fixing the thermocouples

Accessories

For longer two-handed work the RHND-A articulated double hand rest is available.