Spare tool boards for tool case 00 21 42, set of 2, 350 mm - Knipex 00 21 99 V17

A broken tool board leaves the pliers and screwdrivers in tool case 00 21 42 without support. This original Knipex spare part supplies two tool boards 350 mm long as a direct replacement for the damaged ones.

Benefits

• Original Knipex spare part, so the boards fit tool case 00 21 42 without any adjustment.
• Set of two boards, which brings the equipment of the case back to full strength in one go.
• Dimensions 350 x 30 mm, filling the level of the case they are made for.
• The set weighs 872 g and is ordered on its own, so the case itself stays in use.
• According to the manufacturer the item contains no substances of very high concern under REACH.

Areas of use

Repair and refitting of Knipex tool cases in the workshop, in service work and in the store room. The item is intended for tool case 00 21 42 and restores the tool holder level inside the case.

Standards and compliance

The manufacturer states REACH compliance as contains no substances of very high concern. The RoHS directive is not applicable to this spare part.