Precision circlip pliers for external circlips on shafts, tips angled 90°, 210 mm, blister - Knipex 49 21 A31 SB

Circlips on shafts often sit deep inside a housing or behind a shoulder, where straight tips cannot reach the ring properly. The precision circlip pliers 49 21 A31 work with tips angled at 90° and an overall length of 210 mm, so the ring can be gripped safely even from a recess and guided along the shaft. The pliers are supplied on a self-service card in a blister pack.

Advantages

• Inserted tips instead of turned tips, for up to ten times the service life in continuous use.
• Large contact faces at the tips, so the ring does not twist while being fitted and assembly is easier.
• Screwed joint for a precise movement of the pliers without play.
• Opening spring located inside the joint, where it is protected and captive.
• Handles with a non-slip plastic coating for good control even with oily hands.
• Tips angled at 90°, which keeps hard to reach circlips within range.

Areas of use

Mechanical engineering and plant construction, maintenance, gearbox and drive technology and vehicle workshops. Wherever external circlips on shafts have to be fitted and removed in tight or recessed positions.