High leverage end cutting nippers for hard and piano wire, 64 HRC, 140 mm, blister - Knipex 67 01 140 SB

Wire, nails and rivet ends frequently have to be cut close to the surface, and what counts is how much force is left in the hand. The 67 01 140 high leverage end cutting nippers match cutting angle and leverage ratio so that cutting performance stays high while the effort goes down. The cutting edges are additionally induction hardened and reach an edge hardness of approx. 64 HRC. This version measures 140 mm and comes on a self-service blister card.

Benefits

• High cutting performance with less effort thanks to the matched cutting angle and leverage ratio, which relieves the hand during repetitive work.
• Cutting edges for soft and hard wire as well as piano wire, one tool covers the usual wire grades.
• Additionally induction hardened edges of approx. 64 HRC keep the cutting surfaces sharp over long service.
• End cutting head works right in front of the tip and therefore flush with the workpiece surface.
• The short design also copes where space is tight. Overall length 140 mm.
• Black atramentized body and plastic coated handles give a secure grip during forceful cuts.
• Self-service blister card, so the item is ready for shelf presentation.

Areas of use

Metalworking and locksmithing, assembly and maintenance, fencing, concrete and reinforcement work as well as general workshops, wherever wire, nails or rivet ends are cut flush.