End cutting nipper for binding wire, hardened edges, 180 mm, blister card - Knipex 68 01 180 SB

When tying rebar the binding wire has to be tensioned at the knot, twisted and cut off flush right afterwards. The 68 01 180 SB end cutting nipper grips the wire from the front and does both jobs with one tool, and its 180 mm length still sits calmly in one hand.

Advantages

• For twisting and cutting binding wire, both steps are done with the same tool.
• The head shape allows an optimised sequence of movements when tensioning the tying knot during rebar work.
• Cutting edges for soft and hard wire, so tough binding wire and wire offcuts on site are no problem.
• Additionally hardened cutting edges with a hardness of approx. 61 HRC, which keeps the edge sharp over many cuts.
• Black atramentized pliers body and plastic coated handles, easy to hold even with work gloves.
• Length 180 mm, handy right at the rebar.

Areas of use

Rebar and reinforcement work on site, fence and mesh building, metalworking shops, agriculture and general maintenance. It earns its place wherever wire has to be cut at the front of the workpiece and flush with the surface, where a side cutting tool cannot reach.

SB version

This version is supplied on a self-service blister card for display racks. The tool itself corresponds to the 68 01 series in 180 mm length.