End cutting nipper for binding wire, hardened edges, 200 mm, blister card - Knipex 68 01 200 SB

Tensioning binding wire at the tying knot and cutting it off straight away costs strength if the tool is too short. At 200 mm the 68 01 200 SB end cutting nipper puts noticeably more leverage behind the cutting edges and cuts the wire close to the knot.

Advantages

• For twisting and cutting binding wire, both steps are done with the same tool.
• The head shape allows an optimised sequence of movements when tensioning the tying knot during rebar work.
• Cutting edges for soft and hard wire, so tough binding wire and wire offcuts on site are no problem.
• Additionally hardened cutting edges with a hardness of approx. 61 HRC, which keeps the edge sharp over many cuts.
• Black atramentized pliers body and plastic coated handles, easy to hold even with work gloves.
• Length 200 mm, more leverage for fast work.

Technical data

Areas of use

Rebar and reinforcement work on site, fence and mesh building, metalworking shops, agriculture and general maintenance. It earns its place wherever wire has to be cut at the front of the workpiece and flush with the surface, where a side cutting tool cannot reach.

SB version

This version is supplied on a self-service blister card for display racks. The tool itself corresponds to the 68 01 series in 200 mm length.