CoBolt XL compact bolt cutter 250 mm with cutting recess, 40 times force gain - Knipex 71 31 250 SB

Cutting hard round stock by hand takes effort, and that is where the CoBolt XL comes in. Its special joint design multiplies hand force 40 times and saves around 60 percent of the effort compared with conventional high leverage side cutters, while the recess in the edge takes the wire close to the pivot. This version comes on a self-service blister card for display racks.

Advantages

• 40 times hand force increase through the special joint design, which brings even very hard materials within reach.
• Around 60 percent less effort compared with conventional high leverage side cutters.
• Cutting edges with a recess make round stock such as hard wire easier to cut through the better leverage effect close to the pivot.
• Inductively hardened precision cutting edges of about 64 HRC for long service life on hard materials.
• Gripping face below the joint for gripping and pulling wires from Ø 1.0 mm.
• 250 mm length for two handed use and maximum cutting force.

Areas of use

Metal work, electrical installation, reinforcing steel work, assembly and maintenance. Whenever hard round stock of larger cross section has to be cut and a long bolt cutter is too bulky.