High leverage diagonal cutter with induction-hardened precision cutting edges, chrome-plated, 180 mm - Knipex 74 05 180 SB

In a tool case what counts is a diagonal cutter that still copes with hard wire at 180 mm. The chrome-plated high leverage diagonal cutter 74 05 180 SB cuts all wire types including piano wire with induction-hardened precision edges of about 64 HRC.

Benefits

• Cutting angle and leverage ratio are matched to each other, which gives high cutting performance at low effort.
• Precision cutting edges additionally induction-hardened to about 64 HRC, so the edge stays sharp for a long time.
• Suitable for all wire types including piano wire, no extra tool needed for hard wire.
• Built for very tough, continuous use, ready for daily work in workshop and assembly.
• Comfort handles made of three ergonomic components with two KNIPEXtend interfaces for extensions.
• Chrome-plated pliers, 180 mm overall length, SB version supplied in a self-service pack.

Areas of use

Electrical installation, metalwork, assembly and maintenance as well as service work where wire, nails and cable have to be cut cleanly. The 180 mm body stays handy even in a tight tool pouch, and the SB version is aimed at shelf and counter sale.

Note on the technical data

The manufacturer publishes no separate data page for the SB version. It differs from the base version 74 05 180 only in the self-service packaging. As weight, dimensions and EAN of the packed variant are not documented, this description deliberately carries no table of individual values. Length and surface finish are taken from the catalogue designation of this article.