Electronics diagonal cutter with round head without bevel, 115 mm, blister card - Knipex 77 22 115 SB

When a component lead should end as flat as possible above the solder joint, any remaining bevel on the cutting edge gets in the way. The 77 22 115 electronics diagonal cutter therefore has a round head without bevel, the cutting edges run out without a chamfer. Overall length is 115 mm and this version comes on a self-service blister card.

Benefits

• Round head without bevel, the cutting edges run out without a chamfer and separate the wire very flat.
• Durable, load-optimised design with a backlash-free box joint, the cutting edges stay accurately aligned over many cuts.
• Slim multi-component grips drawn up towards the head allow fine and comfortable gripping between thumb and index finger.
• Less physical effort thanks to the high transmission ratio, the load-optimised shape gives a more direct feel when working.
• Low-friction double spring for smooth and even opening, the cutter is ready again immediately after every cut.
• Cutting edges additionally laser hardened to about 62 HRC, which keeps them sharp over a long service life.
• The mirror-polished head with a fine oil film protects against rust, no circuit faults caused by flaking chrome particles.

Areas of use

Electronics manufacturing, board assembly and rework, precision mechanics and model making. The cutter separates thin wires and component leads wherever as little material as possible may remain above the solder joint.