Electronic Super Knips® electronics side cutter 125 mm with wire catcher, blister card - Knipex 78 13 125 SB

When populating and reworking printed circuit boards, wire ends have to be cut close to the solder joint without the offcut flying into the assembly. The Electronic Super Knips® cut flush wires from 0.2 mm diameter with their precisely shaped tips and hold the cut end with the built-in wire catcher. This version is supplied on a self-service blister card.

Advantages

• Precision pliers for the finest cutting work, for example in electronics and precision engineering.
• Ground, very sharp cutting edges without bevel, the precisely shaped tips also cut flush wires from 0.2 mm diameter.
• Shear cut with controlled micro cutting edge offset for a long service life and an ultra precise cut even of the thinnest wires.
• Wire catcher holds the offcut, so cut wire ends cannot fly away uncontrolled.
• Joint with stainless steel rivet and an extremely easy action for low-fatigue work throughout the shift.
• Opening spring with opening limiter, cutting edge hardness approx. 54 HRC, INOX tool steel.

Areas of use

Electronics production and repair, assembly and rework of printed circuit boards, precision engineering, laboratory and model making. The wire catcher pays off wherever cut wire ends must not drop into the assembly.