Electronic Super Knips precision electronics nippers 125 mm, blister card - Knipex 78 81 125 SB

When populating and reworking circuit boards, component leads have to be cut close to the part without stressing the solder joint. The Electronic Super Knips cuts flush-lying wires from Ø 0.2 mm with exactly shaped tips and runs so smoothly that even long runs stay comfortable.

Benefits

• Exactly shaped tips cut flush-lying wires from Ø 0.2 mm right at the solder joint.
• Shear cut with a controlled micro bevel offset for an ultra precise cut on even the thinnest wires and a long service life.
• Precision-ground cutting edges with a very small bevel, additionally induction hardened to approx. 62 HRC and therefore also suitable for hard wire.
• Joint with a stainless steel rivet and an extremely smooth action for fatigue-free work throughout the shift.
• Opening spring and opening limiter keep the nippers ready to cut and limit the handle travel.
• Special tool steel, black atramentized, with multi-component grips, overall length 125 mm.

Areas of use

The finest cutting work in electronics and fine mechanics. Shortening component leads after soldering, cutting thin stranded wire to length, trimming component legs in prototype and model building. The light action also suits workstations where cutting goes on for hours.

This version carries the suffix SB and is supplied on a self-service blister card. Tool and technical design correspond to the 78 81 125 nippers.