Cable shears with twin cutting edge for cables up to Ø 20 mm, one-handed use, 200 mm - Knipex 95 11 200 SB

From around 50 mm² upwards a one-handed cable cut becomes hard work, because sheath and conductors have to be severed at the same time. The cable shears 95 11 200 with twin cutting edge split that job and therefore handle copper and aluminium cables up to Ø 20 mm (70 mm²) one-handed, at an overall length of 200 mm.

Benefits

• The twin cutting edge divides the process into a pre-cut of the insulation in the front cutting area and a final cut of the conductors in the rear area, so cables up to Ø 20 mm can be cut one-handed.
• For cutting copper and aluminium cables up to Ø 20 mm (70 mm²), smoothly and cleanly, without crushing.
• Low effort thanks to favourable leverage ratios and a special cutting edge geometry.
• Hardened, precision-ground cutting edges bite cleanly and keep their sharpness.
• Adjustable self-locking screw joint keeps the action free of play in the long run.
• The pinch guard prevents crushing injuries when the handles close.

Areas of use

Electrical installation, switchgear and distribution board building, cable assembly and maintenance. Wherever supply cables up to 70 mm² are shortened and there is no room for two-handed cable shears, the twin cutting edge shows its value. The shears are not suitable for steel wire or hard drawn copper conductors.

Packaging

The suffix SB marks the self-service packaging. Tool and finish are identical to version 95 11 200, but the shears are supplied on a blister card for the sales display.