ESD Safety Low Shoe alu-tec 62 2.0 S2 Width 12, Nubuck Leather, Black - Atlas 15812

A department order rarely fails because of the model and often because of individual wearers for whom the standard width is too tight. For those cases the alu-tec 62 2.0 comes in width 12, identical in construction to the standard version and with the same aluminium toe cap to EN ISO 20345:2022 at 200 joules and 15 kN.

What sets this shoe apart

• Dissipative to DIN EN 61340-5-1: the shoe drains the wearer's static charge through the sole instead of carrying it to the next component. This is the basic requirement for an EPA to work at all.
• Width 12 instead of the standard width 10, two widths more room across the ball and instep. For strong feet and for wearers of an insole that no longer fits in a standard shoe.
• alu-tec aluminium toe cap to EN ISO 20345:2022, tested at a minimum of 200 joules impact energy and 15 kN compression. Aluminium weighs less than steel, shifts the centre of gravity towards the middle of the foot and forms no cold bridge into the shoe.
• S2 does without a puncture resistant midsole. That saves weight and stack height and is the right choice where no nails or swarf lie on the floor, for example in assembly, inspection and warehousing.
• The MPU INNOFLEX sole system guides the force along the INNOFLEX line from heel to toe. The CLOUDZONE in the heel and the energy absorbing MPU tread surfaces take up the impact and return it into the next step.
• SOFT nubuck leather from full grain cowhide about 2 mm thick, breathable and soft from day one. There is no long break-in period, which counts on a department order with many wearers.
• The aktiv-X functional lining actively regulates moisture, does not stain and is abrasion resistant. After the shift the shoe dries through quickly.
• Approved for orthopaedic insoles per DGUV rule 112-191. Anyone who wears an insole does not have to fall back on a safety shoe without approval.

Areas of use

• Electronics manufacturing and EPA areas to DIN EN 61340-5-1
• Assembly and inspection stations close to cleanrooms
• Light assembly and laboratory work
• Indoor warehouse and order picking

Standards and conformity

• EN ISO 20345:2022, protection class S2 with the slip resistance SR tested in addition on tile with glycerine. S2 means a closed heel area, antistatic properties, an energy absorbing heel and resistance to water penetration and water absorption. A puncture resistant midsole is not part of it.
• DIN EN 61340-5-1 for the ESD workplace. The shoe is the dissipative link in the chain of person, shoe and floor.
• PPE Regulation (EU) 2016/425, risk category II.
• DGUV rule 112-191 for orthopaedic insoles.

Sizes

The article covers sizes 36 to 49, every size in width 12. The required size is selected when ordering.