Centre-grip nutrunner ErgoSpin ESM025SD-G, 5 to 25 Nm - Bosch Rexroth 0608841256

Centre-grip nutrunners are used in manual assembly where the handle should sit between motor and output. The ErgoSpin ESM025SD-G belongs to this design and, per manufacturer designation, covers 5 to 25 Nm. The tightening sequence is set by the Rexroth tightening controller it is operated on.

Benefits

• Working range of 5 to 25 Nm for small joints
• Centre-grip design from the ErgoSpin family
• Same torque range as the ESV025-G straight nutrunner, an alternative design for the same joint
• Runs on a Rexroth tightening controller, either the CS351 compact system or tightening system 350

Specifications

Applications

• Manual assembly of modules with low tightening torques
• Controlled tightening on assembly lines
• Stations where the centre-grip design suits the fastening point

System compatibility

• CS351 compact tightening system
• Rexroth tightening system 350
• Handheld tool cables of the S-... series