Nylon Prober, Fork Blade, 178 mm, Glass Filled, for Opening Cases and Positioning Leads - Desco 35619

Opening the cases of phones, laptops or meters calls for a tool that leaves no scratches and causes no short circuits. This Menda fork blade prober is made of 15 % glass filled nylon and is 178 mm long. The flat screwdriver surface spudges wire leads down flat on the board, and the pointed end forms leads or holds parts while soldering.

Key benefits

• Nylon finish will not mark delicate surfaces, ideal for prying open plastic cases and popping out batteries.
• Glass filled nylon is dimensionally stable and temperature resistant.
• Two working ends: flat surface for pressing down leads, point for forming leads and holding parts while soldering.
• Non-conductive, no risk of shorting assemblies.

Applications

Opening plastic cases, removing batteries, positioning and pressing down wires during hand soldering and electronics repair.

Standards

Note on EPA use: nylon absorbs moisture. After a few minutes of handling with bare hands the tool may be suitable for use near ESD sensitive components. When used with gloves in a clean environment it must be dipped in a topical antistatic solution before use, and the treatment should be repeated every six months. Without moisture or treatment nylon is insulative and charges will not drain to ground.