ESD table top Sintro direct-coated ESD board, with cable cut-outs, 1230x900 mm - Karl 25.930.87

Cables from soldering stations, power supplies or meters should not run over the table edge. This 1230 x 900 mm SINTRO table top therefore has two Ø 80 mm cut-outs that take leads straight down to the power supply strip or cable tray. Made of direct-coated ESD board, 27 mm thick, it is designed for EPA workstations.

Benefits

• Two Ø 80 mm cable feed-throughs with closable plastic covers.
• Direct melamine-resin coating in light grey (RAL 7035), moderately abrasion and scratch resistant.
• Volume-conductive core board, resistance to ground RA 1 x 10⁴ to 1 x 10⁹ Ohm (dry measurement to IEC 61340-5-1, 100 V).
• Slightly textured, glare-free surface, hard-wearing edge banding all round.
• Resistant to organic solvents, weak acids and alkalis, petrol and oil.

Matching accessories and variants

• Same top without cut-outs: KARL 25.920.87
• With cut-outs in high-pressure laminate (EN 438): KARL 25.930.88
• With cut-outs in conductive ESD high-pressure laminate (EN 438): KARL 25.930.89
• With cut-outs in beech multiplex, natural: KARL 25.930.85
• SINTRO ESD table frame standard 1230 x 900 mm: KARL 26.006.70

Applications

• EPA workstations in electronics manufacturing and repair
• Soldering and test stations with several connected devices
• Assembly workstations with power supply strip