Soldering Tip Conical Sharp 0.4 mm, 30° Bent, for TD-100 - PACE 1124-0015

Under a stereo microscope the iron has to be held at a shallow angle so it stays out of the field of view. The 30° bent conical sharp tip with a 0.4 mm diameter still meets the pad squarely in this position. Its 15.1 mm length also reaches joints set lower on the board.

Benefits

• 30° bend: ergonomic grip, clear view from above
• 0.4 mm point: pinpoint work on 0402 and fine-pitch pins
• 15.1 mm length: reach between tall components
• For the TD-100 and TD-100A with IntelliHeat

Specifications

Applications

• Work under microscope and magnifier
• 0402 chip parts and fine-pitch ICs
• Single-pin touch-up and jumper wires

Compatibility

• TD-100 and TD-100A soldering irons (IntelliHeat)
• ST 30, ST 50, ST 70, ST 100, MBT 301/350 stations