Soldering and desoldering tips
Tips for TD-100
This category holds soldering tips for the PACE TD-100 iron on IntelliHeat stations. Each tip is a tip-heater cartridge with the heating element placed directly behind the working surface. The range covers conical tips from 0.2 mm, chisel and bevel shapes, and MiniWave and Micro-Wave concave tips for drag soldering, with widths up to 6.35 mm. Tips for the TD-200 AccuDrive belong to the 1130 series and are listed in the neighbouring category.
Find the right tip shape
These shortcuts filter directly within this category.
ConicalFor single pads, fine pitch and small chip components.pinpoint heat
ChiselFor pads, leads and larger solder areas.wide contact area
BevelFor pads approached with the iron held at an angle.flat contact
ConcaveMiniWave and Micro-Wave for drag soldering QFP, SOIC and TSSOP.solder reservoir
BentFor joints reached at an angle and on densely populated boards.angled head
- 65 items
- 1 manufacturer
- Net prices plus VAT
Buying guide
How to choose Tips for TD-100
What matters when choosing: properties, comparison and typical applications.
Selection criteria
| Criterion | Options | Note |
|---|---|---|
| Tip shape | conical, chisel, bevel, concave, spatula, knife | The shape follows the joint: a point, an area or a whole row of pins. |
| Width | 0.2 to 6.35 mm | The more heat the joint absorbs, the wider the tip. |
| Design | straight, bent, extended, tapered | Extended and tapered tips reach pads between tall components. |
| Series | 1124, 1126 Long-Life Diamond, 1128 Gold Series | Long-Life Diamond is designed for extended service life. |
| Handpiece | TD-100, TD-100A | Operated on IntelliHeat stations. |
Applications
Fine pitch and chip components Conical tips from 0.2 mm put the heat onto a single pad.
Drag soldering MiniWave and Micro-Wave tips carry solder in the concave as they are drawn along the pin row.
Dense assemblies Tapered and extended tips reach joints between tall neighbouring components.
Heat-hungry joints Wide chisels transfer heat over a large area to ground pads and terminals.
Pin rows and bridges The 6.35 mm knife tip heats whole pin rows and removes solder bridges.
FAQ
- Which stations do these tips work with?
- The tips are made for the TD-100 and TD-100A iron. It runs on IntelliHeat stations such as ST 30, ST 50, ST 70, ST 100, MBT 301 and MBT 350.
- How do the 1124, 1126 and 1128 series differ?
- The 1126 Long-Life Diamond series is designed for extended service life. 1128 is the Gold Series, and 1124 includes the MiniWave and Micro-Wave tips among others.
- When to use MiniWave and when Micro-Wave?
- MiniWave concaves from 1.6 to 3.05 mm are intended for drag soldering QFP and SOIC. Micro-Wave at 1.1 mm carries less solder and suits pin pitches around 0.5 mm, for example TSSOP and fine-pitch QFP.
- Which tip width makes sense?
- The tip should cover the pad well without touching neighbouring pads. A tip around 1 mm is enough for chip components and SOIC pins, while chisels from 3 mm suit ground pads and connector strips.