Plywood board for wire harness frame, 1230 x 920 mm - Reeco RF-037-123092-SK

A harness lying flat on the worktop forces the operator into a stooped posture for hours. The wire harness frame tilts the work surface to an angle where all branches stay visible and the arms are relieved.

Two adjustment types are available. The manual version is set via a detent, while the version with the M suffix adjusts the angle electrically and is intended for benches reset several times per shift.

Workstation build-up

• Wire harness frame in 1200, 1530 or 1830 mm width
• Manual or electric angle adjustment
• Plywood board as work surface, matched to the frame width
• Panduit tiles 305 x 305 mm as an alternative layout surface
• Antistatic RAL 9003 coating

Selection note

Frame, work surface and tiles are ordered separately. The number of tiles follows the frame width, 12 pieces for 1230 mm, 15 for 1525 mm and 18 for 1830 mm.

Applications

Assembly of wire harnesses and cable sets, prototype build, rework on vehicle wiring.