Torque wrench MANOSKOP 755/30 clicking type 60-300 Nm insert tool mount 14 x 18 mm - Stahlwille 50010030

On assembly lines and in repetitive production, the same joint is tightened to the same torque again and again. The MANOSKOP 755/30 clicks in the range 60-300 Nm (40-220 ft·lb) with a dual stop signal and works with an accuracy of ± 4%. It has no adjustment scale: the release value is set with test equipment, or Stahlwille supplies it pre-set at a defined torque with certification for an additional charge. At a length of 609 mm, the particularly slim design weighs 1210 g.

Benefits

• Clicking type with dual stop signal, for work on assembly lines and repetitive production tasks
• Particularly slim design, handle and shaft made of square steel pipe
• Further loading after clicking or loads against the direction of operation (up to the max. measuring range) do not affect the trigger mechanism, which protects it from damage
• 14 x 18 mm holder for interchangeable insert tools, counter-clockwise tightening by turning the insert tool over
• Adjustment with test equipment, e.g. STAHLWILLE test devices no. 7707 W, SmartCheck, the perfectControl calibration system no. 7794 or calibration systems no. 7706 and 7791
• Can be supplied pre-set at a defined torque value with certification (additional charge)

Applications

Repetitive bolted joints with a fixed target torque in aircraft engines, the automotive industry, rail, agricultural machinery, commercial vehicles and wind power, especially on assembly lines and in series production.