Ultra fine soldering tip conical 0.2 x 5.1 mm, UFTC series - Metcal UFTC-7CN02

The smaller the part, the less tip mass may sit between cartridge and pad. The UFTC-7CN02 cartridge from the UFTC series brings a conical tip with a diameter of 0.2 mm and a length of 5.1 mm to the MX-H2-UF UltraFine soldering iron and holds 412 °C while doing so.

Benefits

• Tip diameter of 0.2 mm for 0201 and 0402 size components as well as fine rework wires
• Straight tip alignment for direct access to the pad from above
• Self regulating tip temperature of 412 °C with no calibration and no temperature controller
• Cartridge principle: heater and tip are changed together, so heat transfer stays consistent over the service life
• Tip length of 5.1 mm for a controlled view of the joint

Technical data

Applications

Fine soldering and rework on assembled printed circuit boards, for example on 0201 and 0402 size components as well as fine rework wires. Typical settings are laboratory production, repair benches and prototyping in electronics manufacturing.

Compatibility and scope of delivery

Suitable for the Metcal MX-H2-UF soldering iron and the MX-5000 and MX-5200 systems. Delivery consists of one UFTC-7CN02 cartridge without handpiece and without power unit.