Chisel soldering tip, bent, 3.2 x 1.5 mm, C250 series - JBC C250418

The JBC C250418 is a chisel-shaped, bent soldering tip of the C250 series with an integrated heater. The angled 3.2 x 1.5 mm blade transfers high heat straight to the joint and is designed for larger solder pads, ground planes and through-hole connections that fine tips struggle to reach.

Benefits

• Chisel face 3.2 x 1.5 mm for high heat transfer on larger joints
• Heater integrated in the tip for fast heat-up and precise temperature control
• Bent alignment for good visibility and easier access to the joint
• Tip length 12 mm, total length 100 mm for ergonomic work
• Hot tool change thanks to the C250 cartridge design

Applications

Suitable for general soldering with higher heat demand, larger pads, ground planes, through-hole components and wire connections in electronics manufacturing and repair.

Compatibility and scope of delivery

Compatible with the JBC AL250 and AP250 soldering irons. Supplied as a single piece (one tip with integrated heater cartridge).

RoHS compliant, supports ESD-safe work to IEC 61340-5-1 when used with a JBC station. Made in Spain.